Requirements for Calico with Mesos

1. etcd

Calico uses etcd as its datastore. Ensure you have an instance of etcd running, and that it is accessible from all agents in your cluster.

In order to maximize availability, use etcd’s clustering guide and run etcd across the masters or other dedicated hosts.

For simplicity, you can quickly get started by running a single instance of etcd using Docker. Run the following command on a master, ensure you’ve correctly set or replaced $ETCD_IP and $ETCD_PORT:

docker run --detach \
	--net=host \
	--name etcd quay.io/coreos/etcd:v3.1.10 \
	etcd --advertise-client-urls "http://$ETCD_IP:$ETCD_PORT" \
	--listen-client-urls "http://$ETCD_IP:$ETCD_PORT,http://127.0.0.1:$ETCD_PORT"

Check that etcd is up and running:

$ curl http://$ETCD_IP:$ETCD_PORT/version
{"etcdserver":"2.2.5","etcdcluster":"2.2.0"}

2. Docker Configured with Cluster Store

Under the covers, Calico networks Docker tasks for Mesos with its Docker CNM plugin. Multihost Networking in Docker requires that each Agent’s Docker daemon be configured with a cluster store.

Though Docker’s configured cluster-store does not have to be the same as Calico’s, for simplicity, users can configure Docker to use the same datastore as Calico by setting the following flag when starting the docker daemon:

--cluster-store=etcd://$ETCD_IP:$ETCD_PORT

Note: Set or replace $ETCD_IP and $ETCD_PORT with the appropriate address of your etcd cluster.

Restart Docker, then ensure it has picked up the changes:

$ docker info | grep -i "cluster store"
Cluster Store: etcd://10.0.0.1:2379

3. Docker Containerizer Enabled for Mesos Agents

By default, Mesos only enables the “Mesos” Containerizer. Ensure the Docker Containerizer is also enabled on each Agent.

Note: You may skip this step if you do not plan on using the Docker Containerizer.

If you are using the default mesos-init-wrapper from the official Mesos package, you can enable the Docker Containerizer with the following command:

$ sh -c 'echo docker > /etc/mesos-slave/containerizers'
$ systemctl restart mesos-slave.service

4. CNI Isolator Enabled for Mesos Agents

If you are planning to use Calico with the Unified containerizer, enable the CNI Isolator on each agent

Note: You may skip this step if you do not plan on using the Unified Containerizer.

When enabling CNI, you will have specified a network_cni_config_dir and network_cni_plugins_dir. We’ll refer to these going forward as $NETWORK_CNI_CONFIG_DIR and $NETWORK_CNI_PLUGINS_DIR, respectively.

Next Steps

Once you have met the prerequisites, view the Integration Guide